Johnstone's Matt Emulsion is a high quality paint which provides a smooth, rich and non-reflective finish. It is perfect for a contemporary look and to hide surface imperfections. It is suitable for all interior walls and ceilings.
Dry Time : touch dry 1-2 hours and recoatable after 2-4 hours.
Substrate: This paint is suitable for use on interior plaster, wood, metal, plasterboard, concrete, cement render, brickwork & blockwork
All surfaces to be painted should be clean, dry and free from grease and loose or flaking material. Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly. Avoid the inhalation of dust - wear a suitable face mask if dry sanding.
Ensure good ventilation during application and drying. Stir the paint well before use. For best results apply by brush, roller or paint pad. When using a roller, use a medium pile synthetic type. If using a brush or paint pad load generously with paint and apply liberally and evenly, avoid overspreading. Two coats are recommended on all surfaces. If painting over a strong or contrasting colour a further coat may be required. Seal absorbent surfaces first with a coat of emulsion thinned up to 10% with clean water. If more than one can of a colour is to be used in the same area, intermix before use. Do not use below 10°c.
Remove as much product as possible from brushes, rollers and paint pads before cleaning. Replace lid firmly. Clean equipment immediately after use with warm soapy water and rinse thoroughly. Some local authorities have special facilities for the disposal of waste coatings. Do not empty product into drains or watercourses.
Keep out of reach of children
Avoid contact with skin and eyes
Do not ingest
Do not breathe spray. Wear respiratory protection
If medical advice is needed have the container or label to hand
Please refer to the Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling, use, transportation, storage, disposal and emergency.