Johnstone’s Quick Dry Gloss is a high opacity gloss paint for interior and exterior wood and metal surfaces, including skirting boards, doors, radiators and staircases. The water based, low odour formulation is non-yellowing, easy to apply and quick drying.
Dry Time : 1-2 hours
Coverage per Litre : 10m²
Preparation
All surfaces should be clean, dry and free from grease. Remove any loose or flaking paint. Rub down sound glossy surfaces with fine waterproof abrasive paper and rinse thoroughly to provide a key. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Prime bare surfaces with an appropriate Johnstone’s primer. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.
Application
Ensure maximum ventilation during application and drying. Stir well before use and apply by brush or roller. For best results load the brush or roller. Apply liberally and evenly for a smooth finish, avoid overspreading. Under normal conditions the paint is touch dry in 1-2 hours. Allow 3-4 hours before applying a second coat if required. Do not apply when air or surface temperature is below 10ºC or in damp conditions.
Cleaning
Replace lid firmly after use. Remove as much product as possible from application equipment before cleaning. Clean equipment immediately after use in warm soapy water and rinse thoroughly.
To avoid the risk of spillage, always store and transport in a secure upright position.
Do not empty waste paint into drains or watercourses. Some local authorities have special facilities for the disposal of waste coatings.
Precautions:
Keep out of reach of children
Avoid contact with skin and eyes
Do not ingest
Do not breathe spray. Wear respiratory protection
If medical advice is needed have the container or label to hand
Please refer to the Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling, use, transportation, storage, disposal and emergency.
