Johnstone's Speciality Any Surface Primer Paint

The advanced technology, multi-purpose Any Surface Primer can be used on a wide variety of surfaces such as melamine, ceramic tiles, MDF, glass, galvanised metal and uPVC.* Water based and quick drying with superb adhesion to tricky surfaces means you can overcoat with either a gloss or satin finish.

Coverage : 10m² per Litre

Dry Time : 1-2 hours

Preparation

The experts at Johnstone’s know that the key to a perfect finish is in the preparation so take your time now, follow the simple steps below and you will be rewarded with a gorgeous new look. Start by making sure all surfaces to be painted are clean, dry and free from grease and loose or flaking material. Any existing rust, millscale, loose paint should be removed. Lightly sand the surface with a fine waterproof abrasive paper and wipe clean. Please avoid inhaling any sanding dust and always wear a face mask if dry sanding.

Application

Now you are at the stage where you are ready to begin painting so give the paint a thorough stir. Johnstone’s paints are made to the highest standard and are ready to use straight from the tin so there is no need for any thinners. For the best results apply by brush and make sure your brush is fully loaded.

Cleaning

Once you have completed all your painting make sure you remove as much product as possible from your brush and then clean immediately using warm soapy water.

Precautions:

Keep out of reach of children

Avoid contact with skin and eyes

Do not ingest

Do not breathe spray. Wear respiratory protection

If medical advice is needed have the container or label to hand

Please refer to the Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling, use, transportation, storage, disposal and emergency.