Johnstone's Bricks Tiles And Door Steps Paint

Johnstone’s Specialty Paint for Bricks, Tiles and Doorsteps is a protective and weather resistant paint for use on concrete, stone, brick, paving, unglazed tiles, roof tiles and slate.  It dries to an attractive matt finish that will last for years to come.

Coverage : 10m² per litre

Dry Time: 16-24 hours

Preparation

The experts at Johnstone’s know that the key to a perfect finish is in the preparation so take your time now, follow the simple steps below and you will be rewarded with a gorgeous new look. Start by making sure all surfaces to be painted are clean, dry and free from grease and loose or flaking material. Any existing crazed or flaking paint should be removed. New concrete or cement should be allowed to mature for several months before painting. Please avoid inhaling any sanding dust and always wear a face mask if dry sanding.

Application

Now you are at the stage where you are ready to begin painting so give the paint a thorough stir. Johnstone’s paints are made to the highest standard and are ready to use straight from the tin so there is no need for any thinners. For the best results apply using a brush or roller which is fully loaded. Apply evenly and avoid overspreading.

Cleaning

Once you have completed all your painting make sure you remove as much product as possible from your brush and then clean immediately using White Spirit or Turpentine Substitute. Some local authorities have special facilities for the disposal of waste coatings.  Do not empty product into drains or watercourses.

Precautions:

Keep out of reach of children

Avoid contact with skin and eyes

Do not ingest

Do not breathe spray. Wear respiratory protection

If medical advice is needed have the container or label to hand

Please refer to the Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling, use, transportation, storage, disposal and emergency.