Johnstone's Trade Perfect Matt Emulsion Paint

Johnstone’s Trade Perfect Matt emulsion paint creates a flawless finish with ease even on the most challenging surfaces.  Perfect Matt emulsion eliminates the impact of visible application marks even on broad wall surfaces leaving a flat matt finish.  This paint is ideal where the surface and lighting could combine to be a potential issue.

Coverage : 13m² per litre

Dry Time : Touch Dry in 1-2 hours.  Recoatable in 2-4 hours.

Preparation:

All surfaces to be painted should be clean, dry and free from grease and loose or flaking material.  Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.  Avoid the inhalation of dust - wear a suitable face mask if dry sanding.

Application:

Ensure good ventilation during application and drying.  Stir the paint well before use.  Wear respiratory protection.  Easy to apply by brush, roller or paint pad. Also suitable for application by spray. Seal absorbent surfaces first with a coat of emulsion thinned up to 5-10% with clean water.  Do not use below 8°c. 

Cleaning:

Remove as much product as possible from brushes, rollers and paint pads before cleaning.  Replace lid firmly.  Clean equipment immediately after use with warm soapy water and rinse thoroughly.  Some local authorities have special facilities for the disposal of waste coatings.  Do not empty product into drains or watercourses.

Precautions:

Keep out of reach of children

Avoid contact with skin and eyes

Do not ingest

Do not breathe spray. Wear respiratory protection

If medical advice is needed have the container or label to hand

Please refer to the Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling, use, transportation, storage, disposal and emergency.