Johnstone’s Bathroom Mid Sheen Emulsion has been specially formulated to resist moisture and stains. The paint is protected against mould and provides durable protection is areas of high condensation. This low odour formulation dries to a subtle & wipeable mid sheen finish to create a stylish look to your room.
Coverage per litre is 12m²
Dry Time is 1-2 hours
Preparation
Ensure all surfaces to be painted are clean, dry and free from grease. Remove any loose or flaking paint. Any glossy surfaces should be rubbed down with fine waterproof abrasive paper and rinsed thoroughly to provide a key. Avoid the inhalation of dust wear a suitable face mask if dry sanding. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead. All absorbent surfaces should first be sealed with Johnstone’s Bathroom Mid Sheen Emulsion thinned with up to 1 part clean water to 4 parts paint. Ensure to prime bare timber and metal surfaces with an appropriate primer.
Application
Ensure good ventilation during application and drying. Stir the paint well before use. For best results apply by brush, roller or paint pad. When using a roller, use a medium pile synthetic type. If using a brush or paint pad load generously with paint and apply liberally and evenly, avoid overspreading. Two coats are recommended on all surfaces. If painting over a strong or contrasting colour a further coat may be required.
Cleaning
Remove as much product as possible from brushes, rollers and paint pads before cleaning. Clean all equipment immediately after use in warm soapy water and rinse thoroughly.
Precautions:
Keep out of reach of children
Avoid contact with skin and eyes
Do not ingest
Do not breathe spray. Wear respiratory protection
If medical advice is needed have the container or label to hand
Please refer to the Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling, use, transportation, storage, disposal and emergency.